Pinnacle Tvcenter 110i

Tutorial: cutters with ejector (TodoTartas)

Tutorial: multiple cutters shaped ejector rule (TodoTartas)

These cutters I have gotten many thanks to my friend Mar, Store online TodoTartas .

I had heard of them (yes, boys and girls, news about the latest in the world of flying pies ;-)) but still had his eye or hand over. Until now :-)
I've used for this cake with all hearts, and work with fear, glad to do a full row of hearts at once, and on top of various measures without having to go changing cutter size or time. A real estate ;-)

As a picture is worth a thousand words, I leave here below some pictures of their operation. By the way, if you're interested, you know that come with instructions in Castilian ;-) I also give some tips to use them more easily, here are the pictures / links where you can buy the hearts cutter and cutter Script style letters, uppercase and lowercase TodoTartas online store .
Todotartas cutters with ejector:

Before use, clean the cutters with warm water and mild detergent, and dry them well.

can use modeling clay or gum paste with these cutters. You can also use Mexican pasta.

But do not use fondant because it is too soft and sticks to the cutter!

In this first picture you can see the cutter, my small roller (roller nonstick PME 22.5 cm), my favorite spatula Country Kitchen (with a sharp tip) and red modeling clay ( stained with Red Xtra Sugarflair ). The work surface is a cutting board from Ikea (they come in pairs, ranging from wonder, because nothing sticks.) Below is a slip-resistant, so that the cutting board will not move to extend the mass.

Extends modeling clay into a thin sheet and flip it immediately. Let stand a minute or two, and flip it again. Let stand a little (but little). Consider the hearts that want to get, and takes a piece of sheet of sufficient size to cut the hearts you want. Put that piece of foil to dry a little more, that does not stick at all, and cut the hearts at once. If you get stuck and flip on the ejector, hearts will be marked and that's not what you want ;-) Here you see the look of the cutters, which seems a sort of rule double.

Put the above rule, and hold it by the sides. Press hard rule on the pasta, but be careful not to press the ejection system, because otherwise you will be marked hearts. Move the rule a little forward and backward, rubbing the cut surface on the surface.

Here you can see the hearts freshly cut, even in the cutter. You can review the surface with your fingers to remove burrs (but be careful not to press on the hearts). If you let the sheet is dry enough before doing so, should not be necessary.

After only need to press the ejector to release the hearts. So leave the cutter, and here you can also see what is left of the picture of where we have taken, and half a heart could not take over, the thin film ;-)

Here we repeat the process with big hearts (and minor). We measured a bit, we cut, and a ton of hearts at once, yay! ;-)

Now you can remove the rule and smooth cutting profiles finger to turn off all burrs . I do not has been necessary because the sheet was dry enough :-)

joyful hearts And all together ;-)

letter cutter works well, but here it is even more cutting blades as . In this way you work faster and save pasta (because it is widespread and not cut or spare, the dry and not worth much). You can also tape the width of the letters, put it vertically, and tease out, from top to bottom, every letter you need. It works very well. :-)

The trick is the same: press well, without touching the ejector, and move the cutter on the table so that the letters be neatly trimmed.

As with hearts should turn to the cutter (s) letter (s) cut and remove the burrs, if any. And then, once the expeller pressing, remove the letters. Here's the result (yes, I strongly wave Valentine) ;-)

luck (and love ;-)) with cutters!